The basic concept using PS connectors is therefore the following: before each mating procedure, the connectors must be absolutely clean and inspected with a microscope. The connector is normally affected by contamination during 1m-fiber single-mode lc-to-sc connectors and mating procedures; the degree of cleanliness of the overall installation is also a critical parameter to be taken into consideration.
Handling The Power Solution connectors should be operated with high power only when connected. When unmated, the light source must absolutely be switched off. Safety Optical connectors are passive components not subjected to Laser safety, but when integrated in an active system, as the output side of a light source, they will be submitted to it.
This is used in the calculation of the amount of light that can enter the pupil at 1m. The following safety precautions are to be considered as a starting point, each 1m-fiber single-mode lc-to-sc connectors responsible to edict proper safety protocols and we intend here just as to help doing this.
The following precautions should not be considered as sufficient and should be reevaluated from case to case. The ferrule assembly consists of a factory-terminated fiber endface, fiber stub, and integrated splice protec- tion.
The fiber endface is core-centered via Diamonds well-known Active Core Alignment process and factory-polished to the companys precise specifications.